Adjusting the worktop
You can move the worktop forward or backward by 25 mm in
order to align the machine with other kitchen units.
Simply unscrew the two front retaining screws, move the top
to the required position and then retighten the screws.
Fitting under a counter
(kitchen worktop or sink)IN02
By removing the machineOs worktop, you can install it under
a close fitting sink unit or a pre-existing top, providing the
dimensions of the recess correspond to those shown in the
picture.570-600
Proceed as follows:
-Remo ve the machineOs worktop by unscrewing the
two front retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.820
Insert the machine after adjusting height and levelling with450
the adjustable feet.When inserting the machine, ensure that
the water inlet and drain hoses are not kinked or squashed.
IN04
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not
catch on the levelling spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
IN06IN07
19 |
ACEC
